Consistent Module Orientation in Operators
Operators are sensitive to module orientation, but inconsistencies exist between how modules are shown inside operators and how they appear on the conveyor belt (both at entry and exit). This forces users into guesswork when predicting operator behavior.
Suggestion:
Ensure module orientation is displayed consistently across conveyors and operators. This would reduce confusion, improve predictability, and make operator interactions more intuitive.
Operators: Cutter/Assembler/Stamper
Comments: 2
Oldest
•
Newest
•
Most likes
•
Fewest likes
-
24 Sep, '25
quartzarHighlighted comment
They are consistent. They're aligned to the world. I don't think it would even work otherwise, how would you copy an assembler and retain the same, identically oriented output when placing it rotated from original orientation? -
12 Jan
davidHey dev here. Operators are actually not sensitive to module orientation. However it comes in, as long as it's the same dimensions and color, the operator will understand it's the same module even if it was set up in another orientation. Same goes for buildings and cranes, they don't care about module orientation